Home › Repair Specifications › Pull Eye Install

Pull Eye Install

GENERAL PULL-EYE INSTALL SPECIFICATION:

This specification applies to the following types of trench shields:
3M, 4L, 4M, 6M, 8M, T, E, N, K, and LD

SPECIFICATIONS:

• All welding shall be performed according to the Structural Welding Code for Steel – AWS D1.1-90
• A certified welder shall perform all welding.
• 70,000 psi welding rod or wire shall be used to complete the welds.
• The stack Lug shall be manufactured by GME.

PROCEDURE

1. Clean the area to be welded thoroughly with a wire brush or grinding wheel.
2. Weld beveled D-lug (see detail) to item #2 plate. Place the assembly centered on the end of the shield. Follow by welding item #2 to both the interior and the exterior sides of the sheild. See “Top View” for weld details.

NOTE

GME to supply required parts or plate mtl.